Subject | Text |
need wiring diagram intake air temp sensor caddy seville | Hi, I'm looking for a wiring diagram for the intake air temp sensor , showing what color wires go to |
room temp fluctuations for electronic equipment | hi folks,
i have 2 rooms. One is my studio and the other is my bedroom. Problem is, my bedroom i |
|
astra console display | hi, wonder if anyone can help...after replacing my mk.4 astra stereo with a better one, the temp/ ti |
RCA 32674SB | Audio only works on one speaker. I temp. rewired to other speaker to verify both speakers are good. |
| :) Okay: lots of folks experience these type of problems after a move. and they do just what you did |
Old CRT televisions - interesting failure report | Hi everyone,
I am new here & thought this might interest readers & its not a help request. |
Analogue radio repairs | Radios for hard to fix radios
GP300:
Fault…. Doesn't turn On (Dead radio)
1/Check Fuses
2/Resold |
| Just looked, check C958 I'd assume it's on the power supply. Front LED's look normal but the set is |
| I jst replaced the in-dash guages, i mean the entire meter set. I saw the unit is fully electronic. |
| okay, pulled all the bottom boards that were bolted to the tray. Marked all the wires. and cleaned u |
Need Technichan for soldering a circut board | Hello All,
I can not solder very well and I rather pay somebody that spending extra money bu dist |
radio display screen | vax vectra 1999 radio/ temp display screen please |
| It sounds like a bad electrolytic capacitor in the vertical circuit. You would have to know about t |
| Repairing the 61MP1 half screen problem.
I will try and walk you through the process.
I recommen |
| First, check wheter you have anything in the room that can disturb the IR communication from the rem |
| Oops, I thought I posted a reply yesterday, but it hasn't appeared. My fault, probably. I said som |
Sony KD34XBR960 Shuts off only when room warm "4 Blinks | Replaced two DZ boards already. The TV is fine and will stay on for hours if room temp is below 77F. |
|
HELP!!!! HITACHI V700- yellow | somehow the kids were playing with the monitors settings and now the computer monitor has stayed yel |
| use [email protected] I'll get you my personal one from there.
There is a temp sensor on to |
| I have two S113's doing exactly the same - as indicated by bwal.
The self test fails and the Inte |
Nakamichi Pa-7 amplifier | Morning Gilloz,
Thanks for the time investment, much appreciated. I wont pay the astronomical cos |
| If you have already ordered the power supply and do not have any caps or soldering equipment, you ma |
PX-50XM1 (50MP1) | All,
Just so you all know, below are the pcb labels from the scan board of the 2 capacitors which |
LG 42V5 | I have an LG 42V5 that is frequencyerror in it.
The right side of the panels is lot of stripes, |
disassemble toshiba satellite pro 4600 to clean heatsink | hi... about a month ago my laptop started to play rpg game erratically...
i installed the game and |
Bosch KGU30604GB Freezer compartment too warm | Hi,
I have a Bosch frost free fridge freezer KGU30604gb that used to work fine now the fridge is ok |
| Yes I can get into service mode and change any setting available. But no matter what I try to change |
Same problem | I have a CP101 also with the low sound output problem.
I did a temp fix today by substituting Q330 |
Re: LC 4341 | [quote:77042a4005="toudy"]1/ check DC value (+295V DC aprx.) on the PowerSupplyBoard unit -output DC |
LC 4341 | 1/ check DC value (+295V DC aprx.) on the PowerSupplyBoard unit -output DC power for ballast unit
2 |